Discussion: User activation process
Historical. This page holds a discussion from the documentation site of eZ Publish, the system Exponential grew out of. It is kept as it was written, for its history. The comments were written for eZ Publish 3 and 4 and may not apply to Exponential 6.
The current description of the topic is Access control.
In this section
Contributors
- Svitlana Shatokhina
- Massimiliano Bariola Commenter
- Stan Commenter
- Graham Brookins Updated Maintainer
Comments (2 historical)
Written by readers of the earlier documentation sites, kept as they were.
Re: User activation process
Massimiliano Bariola ·
On point 3, I think I can help. look at site.ini file:
[UserSettings]
# If true it will automatically generate a password if it is empty
# and email it to the user.
GeneratePasswordIfEmpty=true
GeneratePasswordLength=6
# The ID of the anonymous user, this user will
# be used for everyone who is not logged in.
AnonymousUserID=10
# Where to store newly self registered users
DefaultUserPlacement=12
So a registered, activated user should go into the "Guest Accounts" user group by default. of course, you may change that behavior.
http://ez.no/doc/ez_publish/techn...ni/usersettings/defaultuserplacement
Bye
Re: Re: User activation process
Stan ·
My users aren't automatically being added to the Guest Accounts group, they are instead sent to the Admin's pending list. How do I bypass this step and have them automatically approved?